AnsweredAssumed Answered

Continuous Weldment Profiles

Question asked by John Guarino on Sep 17, 2015
Latest reply on Sep 18, 2015 by John Guarino

I am creating a small car frame and continue to run into issues with the final appearance using when using the Weldments feature.

 

Example: A sketch shows a horizontal line 20 inches in length and a line snapped one end of the horizontal line of 20 inches at a 45 degree angle. Using the weldments > structural members command and choosing round tubing as the profile the two sketch lines are selected(grouped) and the green check button is clicked. The result is two individual structural members are created.

 

The intent was to create a continuous piece of tubing from the start of the horizontal sketch line to the end of the sloped sketch line.

Outcomes