AnsweredAssumed Answered

Snap Problem

Question asked by Nick Micheli on Sep 14, 2015
Latest reply on Dec 10, 2015 by Evan Stanek

I'm making a new schematic symbol in SWE and I have the grid spacing set to 0.2500. After completing the part, I go to place it into a schematic that also has a grip spacing of 0.2500 but it is way smaller than it was in the editor. Why aren't these spacings equal?

 

I have a training book, but the only mention of grid snapping and spacing is a half-page list of the options that are in the "Drawing Properties" but no elaboration on them.

 

Any help is appreciated. Thanks!

Outcomes