1 Reply Latest reply on Sep 14, 2015 5:27 AM by Stephen White

    error in transfering special loads

    Nakul Farkade

      hi everyone,
      I m changing model component into remote mass. but during simulation it showing errors. like , can anyone plz explain... thanks in advance...Simulation

        • Re: error in transfering special loads
          Stephen White

          Hi Nakul,

           

          A bit difficult to say for sure without looking at the model, but how is the remote load connected to the model, it sounds like an issue with how Simulation is trying to map the remote load to a shell, what have you applied when selecting where the remote load is attached to the model?

           

          Try changing the selecting something different i.e. an edge rather than a face and see if this helps?

           

          Cheers

           

          Steve