12 Replies Latest reply on Apr 3, 2019 3:55 PM by Josh Brady

    Getting error message about modeler limits when adding draft boss extrude of circle

    Finley Woods

      TITLE EDITED BY MODERATOR: Please use short, descriptive titles for posts

      Original title:

      "I am trying to use the Draft Angle Feature on Boss Extruding a Circle. I get the Preview Pop Up for When I just simply want to Extrude the Circle in the North/South Direction. But when I click on the Draft Angle Feature the Yellow Preview Dissappears and"

       

      I get the an Error that says "Resulting Feature is too large to fit in the modeler limits. This operation will fail"

       

       

       

      Message was edited by: Moderator