3 Replies Latest reply on Jan 18, 2019 4:17 PM by Peter Benoit

    Solidworks 2018 Crashing on self made .drwdot

    Peter Benoit

      Good evening everyone,


      I am glad to be back on the solidworks train as I have been on Creo and Inventor the last two years struggling hard with bad interface and occluding items!


      Anyway the reason I am writing this is because when I am creating a title block and saving the sheet as a .drwdot I can open and close it and save it but when I go to put a part onto the sheet (by starting a new drawing) SW crashes without fail and I made it in 2018 too!


      Any suggestions to get it to stop crashing, I try to run solidworks rx on it but it says there is nothing wrong with my system.


      Thanks again,