AnsweredAssumed Answered

Weldment cutlist in 2009

Question asked by Mike Sveda on Jan 27, 2009
Latest reply on Jan 28, 2009 by Mike Sveda

Like • Show 0 Likes0
Comment • 4

How do I get the cutlist items to display on a cutlist bom for 2009?

Are there variables that need mapping for description and length from solidworks cutlist items?

Thanks!

No one else has this question

Outcomes

4 Replies

Joy Garon Jan 27, 2009 6:17 PM
Mark Correct
Correct Answer
Hi Mike -

There is a solution that describes this procedure.
KB Solution S-029566

Regards,
Joy
Like • Show 0 Likes0
Actions
- Mike Sveda @ Joy Garon on Jan 28, 2009 10:04 AM
  Mark Correct
  Correct Answer
  Thanks, I got it working .... sort of....
  
  The cutlist shown in the BOM doesn't seem to show all the cutlist items. I added different features at different versions and the BOM only shows the latest item added. The contains tab is correct though.
  Like • Show 0 Likes0
  Actions
  - Joy Garon @ Mike Sveda on Jan 28, 2009 10:11 AM
    Mark Correct
    Correct Answer
    Hi Mike -
    
    It should work. Essentially, it shows the same BOM you would get if you created the BOM in a SW Drawing. If you find issues, have your VAR open an SR so it can be processed by the support team.
    
    Also, you need to contact them about some of the other issues you posted about.
    I had seen the groups issue in a beta version but mine was corrected. (orphaned group). It 'might' be a similar issue.
    
    Regards,
    Joy
    Like • Show 0 Likes0
    Actions
    - Mike Sveda @ Joy Garon on Jan 28, 2009 11:20 AM
      Mark Correct
      Correct Answer
      I figured it out. I set it as Weldment BOM and not Weldment Cutlist. Now it works.
      Like • Show 0 Likes0
      Actions

Weldment cutlist in 2009

Outcomes

Related Content

Recommended Content