AnsweredAssumed Answered

SW2017 - Mate references stop working

Question asked by Jon Dawe on Apr 27, 2018
Latest reply on Jun 26, 2018 by Neville Williams

HI Folks -

Whenever I drop a hex-bolt, screw, or washer with properly functioning mate references they seem to stop working after a bit.

Meaning, that they seem to stop working after the first part is placed. Typically I use DRAG, COPY to place more fasteners around neighboring holes.

For some reason the mate references seem to forget to work on the next fastener. The work around  to quickly open the fastener file then immediately close it then the drag and drop mate reference will snap into place again but then stops again on the next desired fastener.

 

Thoughts?

Outcomes