I need a macro that will convert the Dimensions Units of all drawings in a folder from decimal inches to fractions rounded to 64ths.
Document Properties > Units > Basic Units > Length
I have been searching, but haven't found one that meets all these requirements.
Replacing the Sheet Format does not do this. Replacing / reloading the Drafting Standard does not do this.
I need something that will replace the Drawing Template. There are many discussions where there is a lot of confusion regarding template vs. format.
I must confess that I have no ability to write macros, so I am totally dependent on getting a self-contained file.
I have nearly 300 drawings to do (this time).
SWx2017 SP 4.1, Windows 7 and 10
I edited my original post to add the underlined text.
Message was edited by: Don Carter