It's "solidworks flow simulation" terminology!
These are the three types availables for a pressure boundary condition.
In fluid dynamics, static pressure is the pressure at a nominated point in a fluid.
In Aerodynamics: To distinguish it from the total and dynamic
pressures, the actual pressure of the fluid, which is associated not with its motion but with its state,
is often referred to as the static pressure, but where the term pressure alone is used it refers to this
In incompressible fluid dynamics dynamic pressure (indicated with q, or Q, and sometimes called
velocity pressure) is the quantity defined by: q = ½ ρv²
In fluid dynamics, total pressure (p0) refers to the sum of static pressure p, dynamic pressure q,
and gravitational head, as expressed by Bernoulli's principle:
p0 p = q + ρgz
The total pressure is also called stagnation pressure.
The basic impact tube consists of a tube pointing directly into the fluid flow. As this tube contains
fluid, a pressure can be measured; the moving fluid is brought to rest (stagnates) as there is no
outlet to allow flow to continue. This pressure is the stagnation pressure of the fluid, also known as
the total pressure or (particularly in aviation) the Pitot pressure.
Unlike static, dynamic and total pressures, the Environment Pressure is not a physical quantity. It is
merely a type of boundary condition in Flow Simulation. The Environment Pressure condition is
interpreted by Flow Simulation as a total pressure for inlet flows and as a static pressure for outlet
flows. If in the course of calculation a vortex crosses an opening with the Environment pressure
condition specified, this pressure is considered as the total pressure for the part of opening through
which the flow enters the model and as the static pressure for the part of opening through which the
flow leaves the model.
Now the question could be: what if you apply static pressure at outlet of equal magnitude instead of environmental pressure, how different your results are going to be?
The only difference between static pressure and environmental pressure depends if there is vortex
flow near the opening. If there is no vortex flow then there should be no difference.
If there is a vortex near the opening, the flow that is coming back through the opening is calculated
using static pressure if a static pressure boundary condition is applied at the opening. If
environmental pressure is used as the boundary condition then the flow is calculated assuming total
pressure. Environmental pressure is more accurate if there is vortex flow near the opening. If there
is no vortex flow near the opening then the results should be the same no matter if you use static
pressure or environmental pressure.