AnsweredAssumed Answered

How to snap ref dimension to center of rectangle

Question asked by Bill Dempsey on Sep 13, 2017
Latest reply on Sep 14, 2017 by Bill Dempsey

Hi

I'm still quite the newbie with SW(2017).  I am attempting to add some reference check-dimensions at the assembly layer.  One of my components in the assembly uses a machined pin with a "chisel" tip.  I'd like to be able to snap to the center of its face as it is a primary reference point for other pieces that tie in to this assembly.

I can't seem to find a way for SW to recognize the center of a "square" face.  Am I missing something?

I am attaching a picture of the assembly. The highlighted blue face is the square pin's face I need to center on.

Any tips?
Bill

 

 

square_pin.jpg

Outcomes