5 Replies Latest reply on Jun 8, 2017 6:16 PM by Peter Kennedy

    Penetrate Pipe not at Center

    Peter Kennedy

      I don't think is possible however I figured I'd ask anyways. I'm making a pipe route that utilizes 14" pipe which a bunch of 4" pipe routes coming off however the the 4" pipe are offset from the center.


      Now when I go to penetrate the point I receive this error:

      Which makes sense because the point isn't located on the pipe center line.


      Is there a way to have the pipe penetrate or will I just have to extrude cut some holes to visually show them?