I tried a section view and it looks ok , see below image
However, if I edit the the cutting line and add a section, then the section view is stretched
Is there an option to avoid this stretch?
it looks like you sketched in the section line instead of using the section assist tool. make sure your vertical lines are set to construction lines, otherwise SW will unfold the section as you see in your image.
Yup... it'd do the trick. Thank you, Jeremy
Christain, in the future, I recommend creating these section views using section view assist, which starts automatically when you start the section view command without a pre-selected sketch. Section view assist will allow you to quickly create any section view, like the one in your example, with just a few clicks, and no pre-exisitng sketch needed.
Thanks for the tip, Matt
I used to draw sketch so I can easily control by dimensioning it
Retrieving data ...