4 Replies Latest reply on Dec 15, 2016 12:14 PM by John Stoltzfus

    Change default settings in loft property manager?

    Peter Crane

      I make a lot of two-profile lofts to simulate bent wire routing in wire harnesses.


      After picking the two profiles, I need to have the following settings as default:


      - Start/End Constraints

           -Start constraint:

                -Normal To Profile

           -End constraint:

                -Normal To Profile


      - Options

           - Un-check Merge result


      If I could have these default settings active every time I start Solidworks it would save me a ton of time!