3 Replies Latest reply on May 3, 2016 1:34 PM by Timothy Taby

    Thread cross section problem

    Felice Pasinetti

      Hi to all,

      I'm having a lot of issues when in a drawing I have to put dimension to a thread cross section.

      Often the dimension lines are not aligned with the thread itself and there is no way to get them in the correct position.


      I contacted my VAR. They told this is a known issue (I'm getting this problem since 2008 version... now I'm with 2016 SP3) and suggested some workaround (more complicated indeed than drawing a fake cosmetic thread).

      Have somebody else the same problem? There is a possible solution to this?


      Thank you