hi
how can i simulate a shaft which rotate from one end and find that resonance frequency in solidwork?
hi
how can i simulate a shaft which rotate from one end and find that resonance frequency in solidwork?
in the frequency simulation just vibrate the part... i want to rotate that ... how can i do that to reach the critical speed of shaft?
If you calculate the natural frequency . then you have critical rpm . on the other hand the natural frequency is Inherent Characteristic of any part . also see natural frequency
good luck
I did 2 frequency analysis by solidworks and abaqus
you can see them the critical speed in first mode is 60 X 11.772 =706.32 rpm
Hi naser
Please check the correct answer (if Has been solved your problem ) to close this discussion.
tanks
Hi
NASER
Go to simulation and start a new study. and run a frequency
fix one end
good luck