AnsweredAssumed Answered

In 2016 thread feature, is it possible to make the thread undersized/oversized for anodization? This would be a valuable tool if it's not there yet.

Question asked by Eric Browning on Oct 26, 2015
Latest reply on Oct 26, 2015 by Matt Taylor

Is it possible to make the thread feature .005" smaller or larger to compensate for hard anodize?  Tool paths are generated from the solid model and then the machinist must make adjustments to make the thread undersized.  It would be perfect if I could just make the solid the correct (modified) size in the first place.

Outcomes