2 Replies Latest reply on May 6, 2015 11:56 AM by Ashley Cheney

Is there a way in SOLIDWORKS Electrical to define the overall lengths of a multiple terminal strip Drawing?

Oliver Smith Apr 17, 2015 10:09 AM

Hello,

Does anyone know if there is a way to define the overall length of multiple terminal strips in a terminal strip drawing? I realise there is a length option in Terminal Strip Drawings within the configuration drop down but this seems to be the length of the individual terminal strip on a drawing. My workaround at the moment is to manually decide which Terminal strips to put on a drawing after I can see that the terminal strip crosses over the drawing boarder.

Any helps would be great thanks!

Olly

Re: Is there a way in SOLIDWORKS Electrical to define the overall lengths of a multiple terminal strip Drawing?

Luis C. Loredo Bellido Apr 16, 2015 1:28 PM (in response to Oliver Smith)

I just make a different drawing for each terminal strip.

Should you have a too long one, then you can insert a page break.
Like Show 0 Likes(0)

Actions
Re: Is there a way in SOLIDWORKS Electrical to define the overall lengths of a multiple terminal strip Drawing?

Ashley Cheney May 6, 2015 11:56 AM (in response to Oliver Smith)

Olly,
I think that there are a few SPRs in the Knowledge Base relating to this question. If you have not reached out to your VAR already, I would suggest that you do so that they can document this as an issue.
SPR 877279, SPR 860031

Otherwise for the time being, I would probably the page breaks manually after you see where the drawings are going off the page as was mentioned.
Like Show 0 Likes(0)

Actions

Go to original post