AnsweredAssumed Answered

creation of structural bevel in lieu of standard angular dimension value available in SW?

Question asked by Dave Krum on Jun 26, 2014
Latest reply on Jun 26, 2014 by Mike Pogue

Good morning all,

Just a quick question regarding the availability of a "bevel/rise&run" symbol in SW.  I work with structural steel drawings where most of the time an angle is shown at rise / run instead of the typical angular value.  See attached with the red circle.  I did some searching online but didn't see anything quite relevant to what I was looking for.  I doubt SW has this capability instead of the standard angular dimension value but thought I'd ask.  Assuming I would need to make a block and put the values in manually where the slope is required to be shown in this format.  Thanks in advance.