AnsweredAssumed Answered

EPDM Revision Table Description

Question asked by Todd Becker on Apr 26, 2013
Latest reply on Jul 8, 2016 by John Fair

I was wondering if there is a way to do the following:


I have a drawing that is being revised. The Designer fills in the Rev block with the following information; Rev, Description, Date and Initials.  Is there a way to push this information in to EPDM? It is my understanding that EPDM does NOT fill in the Revision Block like Workgroups does. I was hoping to at least push this information in the the comments section during check-in or something.




SolidWorks 2013 SP2