-
Re: Syntax Question
Did you carefully double check the name of the custom property for typos or double spaces?
-
Re: Syntax Question
Yes, tried no spaces, all caps, replaced that line with number & discription as the lines above & those show up. Tried "MASS" and that doesn't show either. I would think any proprety name that has a result in the part would display in this note.
-
Re: Syntax Question
Is the view of an assembly or a part? If it is an assembly of just one part perhaps the custom property is set in the part but not the assembly (because $PRPVIEW will reference the top level of the view).
-
Re: Syntax Question
A part. Doesn't matter if it is a single part file, weldment, part of multi-body part, the number & description will read but can't get the sheet metal thickness. Have even tried "STOCKSIZE".
-
-
Re: Syntax Question
The text above is a direct copy out of my note block. If you copy that into a note and make a block out of it then drop it onto a view in one of your drawings it should work the same. I manually change the REQD number (last line).
-
Re: Syntax Question
I tried that and it works for me with all of those properties, I just wanted to look at your custom properties in the part to see if anything stood out to me.
-
-
Re: Syntax Question
Please use "advanced editor" in case you want to attach any files.Click on reply and then click "use advanced editor".
-
Re: Syntax Question
Can you make sure the file you are making drawing of is a sheet metal part? Also check that the property is not there is configuration and custom tabs under Part file properties.
-
Re: Syntax Question
That's it! I thought it was reading from the cut list but once I added "sheet metal thickness" to the summary information it shows up.
Thanks!
-
-
-
-
-
-
-
-
-
