i have a file with STL format (attachment file) . i want to change the file format to STP , IGS or solidworks format . so that i able to add some feature on it
if impossible please help me
I'm not in front of SW but check these posts if the method described here are helpful:
Took the mesh (about 46,000 faces) into Rhino and converted to nurbs, output as iges, imported into SW2009 and saved. Max memory used 2.7 gb and took a fair while to load into SW. Selection in SW is a bit slow. The size does seem wrong though. Its only about 100mm long using mm in Rhino and SW. The fully functional demo of Rhino allows you 25 free saves if you need to redo it. Note there are three very small detached bits of mesh you can probably discard and two main ones. HTH
Rhino gives me an error and says cant run mesh to nurb command for meshes over 20,000... how did you over come this?
Retrieving data ...