2 Replies Latest reply on Dec 10, 2013 6:41 PM by Jerry Steiger

    Translating a sketch from surface to surface.

    Tarakan Tarakanich


      I am trying to translate a sketch from a vertical plane to an angled plane.


      So I copy it and paste it onto a new plane that I angled to a precise angle I wanted...


      I tried to fully define my sketch so I could move it to place and it won't change.

      When I defeined with dimensions, it turned black, however I was not sure what it was hooked to as there were no anchors.


      Why when I fully define a sketch with dimensions, it turns black? I deleted the origin and tried to line this sketch up with previous geometry...

      No luck.


      I cannot move it without distorting it. I run into this problem a lot, with sketches of various complexity.


      What shall I do?


      Whats the official way to do this?


      Thank you.