AnsweredAssumed Answered

revolved cut question

Question asked by Dave Krum on Jun 19, 2013
Latest reply on Jun 19, 2013 by Dave Krum

Hello.  Following up on my question from yesterday (which I marked "correct answer" since my original question was answered), I'm now trying the revolved cut on my railing spindle drawing as suggested instead of doing in 3 parts.  I'm getting the "zero thickness geometry" error even though I thought I was going about the steps the right way.  Suggestions on what I'm doing wrong?  I'm posting the .sldprt as well as a screenshot.  Thanks again.

Attachments

Outcomes