So I have this assembly that when my display style is "Shaded with Edges", lines from the inside parts are showing when they shouldn't be.
I tried messing with the image quality, but they are still there, and I cannot select them to hide them either. It's only in the drawing too, it looks
fine in the solid model. And also, when I change to "Shaded without Edges" it looks fine. Here are some screenshots. The first one is
in the solid model. Any suggestions?
Eddie,
Any transparency turned on?
How about your display drivers. Are they the latest?
Hey Scott,
No, there is no transparency on anywhere.
And my drivers are up-to-date.
Eddie,
Just a note where drivers are concerned. Don't take Windows word for it.
Check that you have a driver tested and approved by SolidWorks, it may or may not be the latest from ATI. With all the variables involved it may not actually make a difference. I.E. Just because SW hasn't had a chance to test and approve the latest driver doesn't mean it won't work fine for SW. Also, if there is more than one approved driver, you might find one works better then another.
I see, thanks for the info.
this post is located in drawings and yet you refer to assembly.
is this a drawing issue or assembly view issue?
if drawing issue, when you print do the unwanted lines print?
when you zoom in do they disappear?
if yes, this is normal behavior.
Yes they do disappear and re-appear when I zoom in and out. Is this a glitch?
it's not really a glitch per se but is an artifact due to the underlying part touching the outer part.
if you separated, by say .001", the artifact would disappear.
there was a recent discussion on this subject.
Yep, that did it. I just moved the part a little ways away from the other part.
Thanks for your help.
I'm sorry I didn't see the beginning of your post here. It's a drawing issue, and when I print the lines print too.
it's not really a glitch per se but is an artifact due to the underlying part touching the outer part.
if you separated, by say .001", the artifact would disappear.
there was a recent discussion on this subject.
https://forum.solidworks.com/message/286998#286998