AnsweredAssumed Answered

URES Displacement

Question asked by S. H on Jan 27, 2012
Latest reply on Jan 29, 2012 by Wayne Matus

Hi all,

 

I am new to SolidWorks and have been designing some parts to be milled. I am using SimulationXpress to analyze whether a part I am designing can handle a load.

 

I am trying to figure out if the below part can hold 150lbs in the downward direction on the front face. The analysis produced the following results.

 

I am not a qualified engineer and, as such, trying to understand the results. Is this suggesting then at the top of my model, with 150lb, it will be displaced by 28.16mm?

 

Screenshot on 1.27.2012 at 6.36.54 PM.png

 

Many thanks.

Outcomes