AnsweredAssumed Answered

Static analyze in sequence

Question asked by Mikael Martinsson on Dec 9, 2011
Latest reply on Dec 12, 2011 by Mikael Martinsson

Hello.

Hope that you can help me with this matter.

 

I need to do a static analyze where loads and restraints are added in sequence. First I have one smaller load and some "on flat surface" restraints. This will cause the part to deform a little bit. After this I add new restraint and new higher loads in new locations to see the final deformation and stress. How can I do this in SW simulation? The real case is on a fixture where clamping and hydraulic supports are added in sequence minimize deformation.

 

Thank you in advance.

Outcomes