AnsweredAssumed Answered

Re-positioning UV-curves

Question asked by 1-SOSNOE on Aug 6, 2010
Latest reply on Aug 12, 2010 by 1-SOSNOE

Hello.

 

So I´m using the surface wizard, guided creation and I extract BSplines from the surface. I can choose to re-position certain UV-curves but not the externals ones. Why? My point is that in previous steps I took my time to cut out the unwanted areas (picture 1), yet when in the surface wizard I get an area that´s bigger again than my desired surface (picture 2).

 

Or did have I misinterpreted those steps? Didn´t I need to cut out so closely and exactly with the pencil-tool, selecting individual triangels? Would it have been sufficient to go roughly around the edges?

 

And when I´m finished, I get a surface like in picture 3. I can not draw on that surface and I don´t know how to cut out the unwanted areas . What do?

 

I hope I could explain my thoughts. If You didn´t understand I can try to upload more screenshots.

Outcomes