AnsweredAssumed Answered

Method to use a pre-existing point sketch with Hole Wizard?

Question asked by Derek Eldridge on May 12, 2020
Latest reply on May 20, 2020 by Derek Eldridge
Does anyone know if there is a way to use a pre-existing sketch with fully defined points as the source for a hole wizard feature?
As far as I'm aware, hole wizard sketches always need to be created in the wizard itself?
 
I'm not looking for a solution of placing points in the hole wizard sketch on top of the pre-existing sketch, thus creating two sketches where the pre-existing sketch drives the hole wizard sketch. 

Outcomes