Hello there!
I have a multibody sheet metal part. I am facing problem in exporting flat-pattern dxf's of the two bodies.
The major problem is when exporting the dxf of the body named 'Back Big'. When I export it, its bendlines are missing.
Sometimes when exporting flat pattern of the body named 'Back Small', incorrect results are found.
Please help me in this. I am trying to solve this issue since a week but could not make it.
Thanks in advance.
Regards,
Bhavarth
Tried it, to me it went fine. Did not measure them though.
Did you select "Bend lines", see image.
Attached are the DXF´s