I would like to see an option for a tool clearance for c'bored holes in the hole wizard.
Tony, just trying to understand what you're looking for here. I'm likely misunderstanding what you are asking for but there is clearance within the holes/counter bores. Could you elaborate on where the "clearance" is missing?
Yes there is clearance for a nut and washer, but I would like to see an additional tab for the clearance for a socket drive to tighten it.
I'll be honest I've never used the hole wizard for much more than Socket Head Cap Screws and Button Heads but I checked a hole wizard version for a 1/4" Hex Head Bolt and the clearance is there.
A 1/4" Hex Head Bolt should have a 7/16" (.4375") flat to flat hex by 5/32 (.1563") thick and the counterbore generated is Ø3/4" (.7500") by 3/16" (.188") deep. Verified a couple of my sockets and the 3/8" drive is approx. Ø.645 while the 1/2" drive is approx. Ø.675 ...
I'm running SW 2016 SP3 if that plays a role.
Retrieving data ...