ds-blue-logo
Preview  |  SOLIDWORKS USER FORUM
Use your SOLIDWORKS ID or 3DEXPERIENCE ID to log in.
VSVarun Sharma02/09/2021

I've attached a cylinder with a wall thickness on both side to be at 0.20" but when you take it into Solidworks DRW to make a print. the thickness always shows .100" I am stuck and missing something geometrically or a SD issue. Can somebody please tell me why the solidworks DRW file is showing only half when it should be 0.20" wall thickness?

i've attached the part file and below is the image of what I am getting when I dimension it out



​​​​​​​