This has to be the most aggrivating thing when using simulate. I'll mesh/run an assembly & be able to view the stress/displacement results. I save the file, exit, & re-open only to be greeted with the "mesh information is not current" warning. Sometimes I am able to view the results again, other times I get a "failed to create a temporary folder" error & have to re-run the simulate to view results again.

I have made NO changes to the geometry at all. Nothing. Nada. Zilch. Some of my FEA runs take 2-3 hours & in order to view the results any time after the initial run, I have to re-run the whole simulation? Is there something I'm missing here?

All of my output directories are on my local hard drive (I'm admin for the workstation), just FYI.