Matthew Lorono

SOLIDWORKS World 2017 Top Ten List: Now Open For Idea Submission

Blog Post created by Matthew Lorono Employee on Oct 10, 2016

Attention all SOLIDWORKS users! SOLIDWORKS World 2017 Top Ten Idea submission is open


The SOLIDWORKS World Top Ten List is now open for idea submission and discussion. The SOLIDWORKS World Top Ten List is an opportunity to submit your ideas for enhancements to SOLIDWORKS. Once ideas are submitted, you will be given the opportunity to vote for your favorite ideas. SOLIDWORKS Development considers all ideas.  The Top Ten ideas will be presented at SOLIDWORKS World 2017 in Los Angeles.


Ideas can be viewed and submitted by visiting the SOLIDWORKS World 2017 Top Ten List area of the discussion forum. Click on “Content” just under the Top Ten List banner. You can also click on the categories on the left side to sort by specific areas of SOLIDWORKS (Assemblies, Drawings, Simulation, etc.). When submitting an idea to the forum, please be sure to assign it within the proper category.  This will allow everyone to find your idea by area of interest while voting is open.  Prior to submitting an idea, please review the ideas already posted to make sure that there are no duplicates.  If you find your idea is already present, feel free to follow it so that you can vote for it later.


As always, we encourage friendly and professional comments and discussions to all ideas that may help clarify or better communicate other uses and needs. This potentially assists others when voting and helps us better understand everyone’s needs and ideas too. Submit your enhancement ideas by December 15, 2016.  Voting will begin immediately the next day on December 16, 2016. Whether or not you’re attending SOLIDWORKS World 2017 in Los Angeles, we look forward to seeing your ideas. You also just may see your idea in a future release of SOLIDWORKS!


Important dates:

  • December 15, 2015 is the end for new idea submissions.
  • December 16, 2015 voting on all ideas begins.
  • January 20, 2016 voting ends.