Glenn Schroeder

How can I get an Assembly cut or Hole Wizard feature to show in my Part file?

Blog Post created by Glenn Schroeder on Dec 23, 2017

Check the box shown below in the Feature's Property Manager, then choose All components or Selected components.  If you choose Selected components you will likely need to un-check the box for Auto-select, and then choose which Part files you want the feature to propagate to.

 

Also keep in mind that if you choose "All components" it will affect components that are added after the feature.  I found this out the hard way (it took me longer than it should have to figure out why my washer didn't look right after it was mated to the hole).

 

Outcomes